Washing Machine Programmed Control PCB Module Stock Number: ES1370338
Genuine spare part for select models of Hoover washing machines
Manufactured by Hoover
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Washing Machine Programmed Control PCB Module
If the printed circuit board (PCB) in your washing machine has fried itself, there's no need to buy a whole new machine as you might be able to fix it yourself by replacing the damaged PCB.
eSpares has this replacement power control board from our range of washing machine spares, which could soon be yours to possibly help the problem.
Specification:
- Programmed
- Type: Invensys
Genuine spare part for select models of Hoover washing machines.
Please check the list of suitable models to ensure that this spare part will fit your appliance.
5 Questions and 5 Answers
I have replaced the PCB for my WMH148DF-80 and it is now showing E15. How do I programme this?? 1 Answer
-
Chris at eSpares says...
There are programmed and non programmed versions of this PCB.. The non programmed version can only be programmed with a lap top or 'MEM loader'. This part is a programmed version and should work correctly.
I purchased a PCB from E Spares,fitted it and it solved its program selection problems,all was well for a while but now the washer is dispaying fault code 03 on a wash program ( not emptying water ) Put the washer on a rinse program and it fills,spins and pumps out ok. HELP ! P.S its a WMH148DF-80
-
Chris at eSpares says...
This is usually caused by a partial blockage of the chamber to the pressure switch restricting the air returning and telling the machine it has not emptied. Try using our machine cleaner a couple of times or until the problem stops and then repeat regularly to help keep your machine free of build up and bacteria.
I have a WMH 148DF-80 washing machine which is constantly switching over from one programme to the next one if I set it, I have to juggle the control knob to make sure it is the correct programme,by changing the board will this solve the problem. 1 Answer
The No below the model no on the door is 3100326010417038. I also could do with a replacement Capacitor for this machine as the brown in feed wire which connects to it burnt off and so I have cut the wire back and re crimped another spade connector to the capacitor . But I would like to replace the capacitor as it is a little burnt around the connection and plastic.
-
Chris at eSpares says...
Yes this should resolve your problem see: How to Replace a Hoover PCB and Timer Selector Problems. http://www.espares.co.uk/advice/7/2369/how-to-replace-a-hoover-pcb-and-timer-selector-problems Stock Number: ES546610 is the mains filter you require.
my switch when turned does not always line up with the right temp we have had it replaced once the knob and marking are still visible we just have to twiddle the knob to make it work on two settings the rest of the settings are ok. I dont want to pay out if unless its minor like the switch behind the knob.
- sounds like it on its way out buy a new PCB Unit
Will this part fit my appliance?
Check Now
