Answer this Question (2 Answers)

• There are 4 screws in the feet. - There are additional screws in the panel where the cable fits through. There is a screw in the bottom of the hinge. Once these are removed, you can slide the base from the top. Turn the machinery over. You should see a motor, a drive belt and a second spindle. Remove the belt - it should stretch enough to jump off the pulley. Unscrew the nut ( about 8mm) on the larger wheel. There is a washer and a rectangular plate to remove. This exposes the bottom of the part in question.remove the large wheel - careful it is a bit fragile! There is a split-cover shaped like a horse-shoe in a groove at the base under the threads. This needs to be prized off with a screwdriver or pliers or both. Once this slides free, the connector joint can be gently tapped and should fall through the hole. - Reassembly is the reverse. So connector through hole, split pin, wheel plate, washer, nut, belt, reassemble and screw together. - Good luck. hope this helps. - A second person to hold the parts is recommended, but not essential! - keep all the parts in a safe place. By A Hummerston - MUNCHKIN HQ OXFORDSHIRE. - 03 November 2018
• 

  Chris at eSpares says...

  In order for us to answer your question or source the exact part you require please provide us with the following information: Appliance make, model and serial number of your appliance. For further help visit the "Finding Model Numbers" page on our website here: http://www.espares.co.uk/findingmodelnumbers. Alternatively please copy and paste this link into your web browser.