Answer this Question (1 Answer)

• Given that your question was posted several months ago, I guess you've found out by this time, but just in case... You need to ease the plastic panel that surrounds the dispenser unit away from the freezer door by inserting a flat blade screwdriver into the slots underneath the bottom of the panel and gently easing it outwards. The panel is held on by simple snap-on hooks (about 8 or 10 around the edges) and they simply pop apart as you ease the panel outward. Work your way around the edges until the whole panel is released. Behind the panel, you will find the PCB at the top, connected by a small cable and held in place by screws. Gently ease the cable connector out of the PCB, undo the screws and you're all set to put in the new board. Reconnect the cable and then replace the panel by just pressing around the edges so that the hooks snap back into place. By toughcookie - - 16 September 2011