Answer this Question (1 Answer)

• 1. Unplug machine. 2. Turn water off. 3. Remove 2 self tapping screws holding front feet assy(large white plastic kick plate) to base located on the sides at the front of the machine. 4. Remove water from machine if any. Take out filter and suck out water from filter housing. 5. Remove door front outer cover panel by opening machine and remove 6 screws holding it on. 6. Tilt machine backwards and place chock underneath to keep it tilted. 7. Remove front leg assy previously unfastened. 8. Move metal plate from behind leg assy. Remove the 2 screws. 1 either side and move metal plate down to access motor. 9. On motor, unclip the electrical cover, remove 2 terminal push on connectors, hold latch device and turn motor assembly towards you. 10. Refitting is reverse instructions. Ensure sealing ring is clean and motor is located securely on re-fitting. 11. As with all electrical work. If in doubt consult a qualified electrician. By Nelsun_2 - Thatcham, UK - 12 February 2011