Tumble Dryer Thermostat Kit Stock Number: ES1063487
Genuine spare part for select models of Indesit, Hotpoint and Whirlpool tumble dryers
Manufactured by Indesit
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Tumble Dryer Thermostat Kit
If your dryer is not reaching the correct temperature or it's getting too hot, then there could be a problem with the thermostat. The thermostat regulates the temperature inside your dryer, therefore its an essential part for the appliance. Luckily, eSpares have the genuine spare thermostat kit to get your dryer back to working order.
Genuine spare part for select models of Indesit, Hotpoint and Whirlpool tumble dryers.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
Please note: this only fits appliances which are fitted with a Blaissi manufactured heater. Prior to ordering please confirm that your dryer has a Blaissi heater. This can be identified by 2 raised dome-shaped pips on the heater cover and a circular element wire. If you require assistance please contact our Call Centre.
6 Questions and 4 Answers
This not heating as hot as usual so taking much longer for the clothes to dry. Is this because one of the thermostats may have gone?
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose Tumble Drier Drying and Heating Problems http://www.espares.co.uk/advice/9/2050
-
Chris at eSpares says...
the most likely cause is the heater or water getting on to the heater if it is a condenser dryer. See our tumble dryer diagnosis videos for more information.
I purchased and fitted these but still no joy. I have a technical question. Prior to ordering, I tested the 'one shot' with an avo and it did not conduct when I pressed it whereas the 'auto reset' did. I removed the 'one shot' and shorted the wires and the elements started to glow when the dryer was switched on. I onlt tested for literally 5 seconds. Confident that the one shot was faulty, I ordered this part but having now fitted it, it does not work i.e. still blowing cold. Strangely, the piece of paper that came with the rder describes a purple spot for the auto reset (mine is a 6kg vented after aug 96) but the auto reset that arrived has no spot. According to the paper, I may have the one that should be fitted to a 6kg condenser. Any thoughts appreciated.
- I am stuck like you in that the description supplied with the part does not describe what they sent me. As there were no fitting instructions I don't know where to look to find the original faulty part so it may be what they sent me is what I need.
my dryer sounds as if its working but its not getting hot at all, do you think it could be the sensors? Any suggestions would be of use please!
- i would imagine that it is the sensors
the model is a Hotpoint VTD20P.when drying it get so hot it cuts out and also the low temp does'nt work
Will this part fit my appliance?
Check Now
