Flymo Lawnmower Switch 14050941 Stock Number: ES1136941
Genuine spare part for select Flymo lawnmowers and lawnrakes
Manufactured by Flymo
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Flymo Lawnmower Switch
Your lawnmower's switch is an essential spare to have on your mower, without it your machine is rendered useless. Replace it with this cost effective, 8 Amp, 250 Volt spare from Flymo. You'll soon have that perfect lawn to enjoy when the sun shines.
Specifications:
- 8 Amps
- 250 Volts
Please note: The switch housing is not included, but can be purchased separately.
This is a genuine Flymo spare part that has been made to fit the select lawnmowers and lawnrakes. Please check the list of appliances before purchase to ensure that this is the right part for your appliance.
Fitting Note: many customers have reported difficulty removing the wires from the old switch.
It may be easier if you photo the old switch to identify where the wires are connected and break the old switch open to release them prior to transferring them.
19 Questions and 22 Answers
Turbo Compact Vision 330
- AndytheB - thanks for the tip with the pin - worked a treat. I used both a safety pin and a pin according to wire size, just pushed the pin in the hole while wiggling the wire and with a bit of persuasion it releases.
- Actually I found the best way to remove the two wires was to prise the back off the switch (doesn't matter if you wreck it). It is then a simple matter of removing the clips securing the wires and pulling them out intact. This way, there is no danger of damaging the solder tags on the ends of the wires, which are useful when refitting. To refit, simply push the wires into the appropriate holes in the new switch and they will latch. Same for the capacitor.
- The way I removed the wire from the old switch was to push a pin into the hole beside the wire and pull. The wires are held inside the switch by a simple spring mechanism!
- In fact, they are just a very tight fit, especially if there is some damp corrosion around. Just get a good grip with long-nose pliers and lever them out against the body - a bit of 'post-hole wobbling' first doesn't hurt.
-
Chris at eSpares says...
Other reviewers suggest breaking the old switch apart (take photo first to identify them).
ny suggestions for a fix.m hanks, ohn fromy rowbridge flymo 360 model cuts out when hot. allow a couple of minutes and it will restart and run for a couple of munutes, then cut out again. 1 Answer
-
Dean at eSpares says...
For help please see our advice centre www.espares.co.uk/advice/symptom/electric-lawnmower-keeps-cutting-out just copy and paste into your browser.
My chevron 32v starts then stops I've fitted a new switch box and capacitor and the wireing is fine what else could it be? Paul 1 Answer
-
Chris at eSpares says...
The wire going to the power switch can break due to movement. Try moving this when the motor is running to see if it cause the cutting out and replace if required.
I just need to open the switch cover first to check any obvious loose wires before buying new switch 1 Answer
Which is the correct screwdriver to open up switch box for the flymo hover compact 300 ?
-
Parminder at eSpares says...
Sorry we do not have this information, however we would recommend taking a picture of the screw head to a local DIY store.
Will this part fit my appliance?
Check Now
