Dishwasher Recirculation Motor - 99W Stock Number: ES475341
Genuine spare part suitable for select models of Whirlpool, AEG, Diplomat and Bauknecht dishwashers
Manufactured by Whirlpool
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Dishwasher Recirculation Motor Spray Pump
If you have noticed that the circulation of water in your dishwasher is not happening as is used to, eSpares might just be able to help! We have this replacement recirculation motor spray pump that could soon be yours.
The function of the recirculation pump is to send the water gathered at the bottom of the appliance, through to the spray arms, and so completing the wash cycle. Say goodbye to having to wash the dishes by hand - we can soon have you back to a fully working dishwasher again in no time!
Specification:
- Type: Askoll
- Model: M234
- 99 Watts
- 50Hz
- 0.45 amps
- Voltage: 230-240
Genuine spare part suitable for select models of Whirlpool, AEG, Diplomat and Bauknecht dishwashers.
Please check the list of suitable models to ensure that this spare part will fit your appliance.
5 Questions and 5 Answers
My dishwasher is not washing properly, at the end of the cycle it looks like the dishes have been 'steamed' rather than washed. from searches on the internet it points to the recirculation pump being at fault and this was apparently a weak point with the Askoll pump. I've stripped the pump off and before I buy another wanted to know how I can test it to make sure, it doesn't appear the same as some on various tutorials, the hose to the body is removable ie isn't bonded at one side and the impellor although it comes off the shaft it has a plastic and rubber drive under it as if it is meant to. The pump fitted is an Askoll M95.1 part number 461972474392, any help would be appreciated.
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose Draining and Motor Problems in a dishwasher: www.espares.co.uk/advice/3/1889
My dishwasher ADL 934 S 1WH, makes a grinding like noise whilst washing. The heater is fine, you can hear it spraying but the finished result is not always perfect, especially when a full load is tackled. Some plates are left with food deposits and not all cutlery is clean. It gets cleaned regularly with espares cleaners and I take the spray arms and filters our frequently to clean them.
-
Chris at eSpares says...
The first thing to say is there should be no food particles left as you should have rinsed these off prior to loading the machine. Dishwashers do not deal with food particles well as they are washed around and broken down. These can end up drying on plates leaving a crusty deposit. secondly insure the spray arms are not catching when fully loaded as this will prevent proper cleaning. The noise is unlikely to be effecting the performance.
how can i tell if its the motor that has gone on my Ignis dish washer, the pump still works as does the first programme 1 Answer
Ignis dishwasher will nor go through the programme cycle it will fill up and drain but will not go through to full programme, element ia also working
-
Chris at eSpares says...
It is common for the first cycle on a dish washer programme to be a cold rinse and if the appliance complete's this correctly it suggests a heat related problem. This could be the thermostat heater,sensor or even a control board problem.
Hi, Do you need any special tools etc to enable fitment of the spray motor and are there any instructions available - Thank You
- You need torx bits to take case to pieces, also cripping pliers to tighten and fixhose clips. No instructions supplied. Hope this helps. Maggie
On our machine it is sealed on to the pump unit but here it appears to be pushed on and held in place with a jubilee clip. it is only the rubber connector on our machine that is faulty - can this be purchased seperately as i do not need the pump/motor unit as well or the expense!
-
Rory at eSpares says...
Hi there, I'm really sorry, but the hose part isn't available as a separate part! It's all manufactured as one part - really sorry.
Will this part fit my appliance?
Check Now
