Tumble Dryer / Washing Machine Door Hinge Stock Number: ES487862
Genuine spare part for select models of Creda, Electra, Hotpoint and Jackson tumble dryers and washing machines
Manufactured by Creda
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Tumble Dryer / Washing Machine Door Hinge
If you have broken the hinge to your washing machine or tumble dryer door, it will impact on how smoothly you can open and close the door, so make sure they are working correctly - as over time, they can become worn and less effective. eSpares has this replacement hinge that could soon get your door functioning again in no time.
Genuine spare part suitable for select models of Creda, Electra, Hotpoint and Jackson tumble dryers and washing machines.
Please check the list of suitable models to ensure that this spare part will fit your appliance.
3 Questions and 6 Answers
- Very easy - 1. Take old hinge off dryer (save two screws). 2. Undo all the screws inside the door. 3. Prize door apart where the hinge goes (just enough to get out the square plastic bushes the hinge spikes fit into). 4.Fit new hinge onto door. 5. Screw the door back on dryer.
- I FOUND THIS EXTREMELY EASY TO FIT...ASSEMBLE HINGE TO DOOR BEFORE HANGING..
-
eSparesToby at eSpares says...
There is just one hinge included, fitting is relatively straightforward and some guys have already left great feedback on the product page with explanations of how they fitted theirs!
Creda 3761 tumble dryer door hinge replacement
- remove the screws in the door and the plastic hinge fitting comes away..easy then to just push out the remaining piece of hinge
- 1 Undo all the screws inside the door. 2. Seperate door inner and outer shells - not completetly, just at the back where the hinge goes (use a screwdriver). 3. Remove the square plastic lugs that the hinge spikes fits into. (You need them out to fit onto new hinge). 4. Push the busted bit of old hinge out with anything long & thin - cocktail stick, nail, etc.
Replaced fastner on door but putting door back pushed the parts still attached to washer where the screws go inside the washer what do i do 1 Answer
-
Chris at eSpares says...
Retrieve the fixing plate from under the machine. Remove either the top or the door seal from the front to allow you to hold the plate in position when you screw the door back to the cabinet.
Will this part fit my appliance?
Check Now
