Dishwasher Door Lock Latch Assembly Stock Number: ES509247
Spare part suitable for select models of Hotpoint, Indesit and Ariston dishwashers
Manufactured by Electruepart
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Dishwasher Door Lock Assembly
If you are washing the dishes yourself after dinner time, all because of a damaged door lock to your dishwasher, eSpares can put the situation right. We have this replacement door lock that could soon get your door securely locked, ready for the washing cycle.
With help from eSpares, you can soon be back to being able to relax after meal times - and let the dishwasher do all the hard work!
Spare part suitable for select models of Hotpoint, Indesit and Ariston dishwashers.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
12 Questions and 24 Answers
- yes it does,my broken one lost spring and pin
- Yes Neil this is a complete item ready to fit
- Yes
- If you mean the coiled spring holding the latch in place then yes. When fitting look how the existing one fits into the "n" shaped groove and edit the extra plastic (gently) until the new one does the same.
- Yes ,spring included
- The switch assembly is the same as the one you remove it contains the housing, the spring and the power switch
- spring included and easy to fit
- yes the spring is included
I have a DWF50 and am worried that removing this internal panel may damage the detergent release catch
- not sure on that model,on mine just took out top four screws and two either side.carefully pull top front and steel inner apart. WARNING mind fingers on edge of inner panel.sharp took chunk out of finger.
- No inner panel stays in place only the top door plastics need removing. Top 8 screws will do the trick.
- You shouldn't need to remove the internal panel to fit this. The screws along the inner edge should release the outer plasic cover only. Note the 2 different threads on the screws and make sure they go back in the same place.
- The dishwasher that I repaired (haier) reqired removal of eight philips head screws to give enough acess to the switch then remove the two screws that hold the switch th the door inner, release and lift out the switch assembly remove the two power wires and refit the new switch in the reverse order. Remember to isolate the power before comensing work.
- I didnt think so but after fitting my new lock something must have happened as it doesnt release anymore
- When you remove all the panel screws its only the outercover on the door that comes off, you dont disturb any of the detergent release catch, hinges etc, the job takes about 15 min!
Have replaced the dock lock, but have been unable to find the spring which broke off from the previous lock. Is it OK to use the dishwasher or do I have to keep searching for the spring?
-
Chris at eSpares says...
It is always recommended to remove any loose parts and they could damage wiring or electronic components. If you have removed the door skin and cannot locate the spring check around the control board and switches. If this is ok then you must use with caution at your own risk.
Do I need to fit a new catch if I am replacing the lock? Or is the old one still ok to use. 1 Answer
-
Chris at eSpares says...
The old catch should be alright to use if undamaged, examine carefully and replace if required.
Will this part fit my appliance?
Check Now
