Pressure Washer K2-K7 Sandblaster Kit

Used to remove paint, rust and cement from metallic and stone surfaces by using a combination of high pressure water and sand.

The Karcher sandblaster uses fine kiln dried sand to remove all manners of stubborn dirt on a wall, concrete floor or a variety of metallic surfaces. The sand can be replenished from most DIY stores, it is advised to use a sand which has a grade between 0.4mm and 0.6mm, of course anything larger could cause damage or a fault to your sandblaster or your Karcher.

To operate the sandblaster attachment, a clear tube runs into a bucket of sand, the sand blaster is connected to your pressure washer gun and then once trigger has been pulled the water jet comes through the sandblaster all while drawing sand out from the bucket.

The concoction of the water, sand and high pressure removes those tough areas of dirt build up or even graffiti.

Specification:

• Includes: Sand blaster nozzle, Clear pipe and Safety goggles
• Sand / Wet Blasting Set
• Removes rust, paint and stubborn dirt
• For K2 - K7 pressure washers.

Genuine spare part for select models of Karcher pressure washers.

Karcher spares reference: 2.638-792.0