Washing Machine Door Seal Stock Number: ES488118
Genuine spare part for select models of Candy, Hoover and Teka washing machines
I m using a Hoover Nextra HNF 2137S-80. Pls let me know how to fix the seal and which tools I require. Thanks
- Hi, I fitted one to a hoover nextra HNF7148-80. I required a 7mm spanner and socket, a screw driver to leaver the front retaining ring off and some washing up liquid to lubricate the inner door seal to help fitting. (well worth doing) Regards and good luck
- Strength, patience, a couple of small adjustable spanners and a flat head screwdriver. Best of luck - the online video is very helpful but it is not a 5 minute job.
- Washing up liquid, small screw driver, and 1/4" drive small socket (7mm and 8mm i think) and spanner
-
Rory at eSpares says...
Hi Giby This door seal is suitable for your Hoover HNF2137S-80 washing machine. For help fitting it, use our handy guide: http://www.espares.co.uk/guides/washing-machines/g/12/38/replacing-door-seals.html
Hi, I have a HJA8552 integrated washing machine, do I need to take it out to remove the rubber door seal? 1 Answer
-
eSpares Staff at eSpares says...
You can remove the door seal without removing the machine but you will be limited for space, watch the video on replacing a door seal on a hoover machine which will help https://www.youtube.com/watch?v=nDvASsHsLA4
-
Chris at eSpares says...
The outer clamp band for your washer is Stock Number: ES488997
In the video the man shows hot to remove top and front of machine but the front does,nt come off ours and also there is a retainer holding in the rubber which we can't get loose so rubber won,t come out can you help with this.
-
Chris at eSpares says...
It should be possible to carefully prise the seal retainer of the outer rim and replace the door seal through the door port hole. Although this is more awkward than the machine in the video.
These marks are easily washed off by hand as it is like a slim ,when run under hot water it will wash away. I have cleaned out machine best I can and run on hot cycles but it still happens
-
Chris at eSpares says...
This problem is likely to be due to a build up of mould and bacteria in the machine. Use Stock Number: ES1566874 eSpares Limescale & Detergent Remover through the machine for two or three cycles and see if this clears it. If this resolves your problem remember to leave the door and soap draw wide open after use until the machine has dried to help prevent the mould coming back.
model no hnl 6166
-
Mathew at eSpares says...
Hi
Variations occur on different machines of course but the above video should be a good start for the basics.
I have a Hoover Optima washing machine - just under 2 years old. It is leaking from the front inside - the water coming down inside the concrete weight. It leaks when water is added to the drum by hand (jugfuls). The water pump connections are all dry. Th 1 Answer
-
Rory at eSpares says...
Hi BobW, it sounds most likely that the problem is with the door seal. Check out this video for help: http://www.espares.co.uk/advice/washing-machines/a/7/1394/how-to-replace-the-door-seal-on-a-washing-mac.html
Will this part fit my appliance?
Check Now