Dishwasher Pressure Switch Diaphragm Stock Number: ES662485
Genuine spare part for select Algor, Bauknecht, Firenzi, Ignis, Ikea, Integra, Neutral, Prima, Ram Program 2000, Tecnik, Whirlpool dishwashers.
- diplomat8233 take in water at side but goes out agan is it pressure switch
-
Rory at eSpares says...
Hi Asheldon, I'm afraid without seeing your appliance it'd be impossible for me to say what was causing this problem. My advice would be to seek a repair man.
started not filling with water put a jug full in and it worked now won't drain water either no flashing light it's on constantly Does nothing when switched on could this possibly be pressure switch? Thanx
-
Chris at eSpares says...
For information on this problem see our diagnosis video: How to diagnose filling and dispenser problems in a dishwasher http://www.espares.co.uk/advice/3/1954
Dishwasher is IKEA DWFB10W. Have already tried washing out the sump without success.
-
Chris at eSpares says...
If your machine is taking in water to fill and coming up with this error then it could be a optical sensor problem depending on who manufactured the appliance (as opposed to who's badge is on it). For additional fault information see our video: http://www.espares.co.uk/advice/3/1985/how-to-diagnose-control-and-programme-issues-with-a-dishw
The flash code above the start button on my ADP 4500 flashes 11 times what do I need to look at and replace 1 Answer
The dishwasher fills and empties several times before it kicks in and starts a full cycle, it is fine after it starts it does the full cycle without any problems
-
Chris at eSpares says...
11 flashes indicates a 'optical water' sensor problem, This is sometimes referred to as a turbidity sensor and flushes the machine till it thinks the water is clean to start. If coffee or tea is spilt into the sump or you have not been rinsing the food off the plates this may be the cause. Try using a dishwasher cleaner like Stock Number: ES1566874
dishwasher is filling with water and emptying. opening of powder compartment is functioning but spray arms are not working. spray arms are clean and not blocked does the salt dispenser have a water level sensor?? or could it be the circulation pump??
-
Chris at eSpares says...
This does sound like a circulation pump problem. Some times if the motor is seized there will be an associated hum as the motor is powered. If the filling water is stopped by the machine then the wash motor should be being powered and it is not likely to be a filling problem.
dishwasher wont wash on 40 degree cycle
-
eSparesMalindi at eSpares says...
Please speak to the manufacturer of the appliance or an engineer to help you with this technical problem.
Will this part fit my appliance?
Check Now